Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Input Speed Sensor Replacement

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Input Speed Sensor Replacement

Removal Procedure
  1. Remove the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement.


  2. Remove the input speed sensor bolt (2) M6 x 23.
  3. Unlock the 2 retaining tabs inside the transmission housing.
  4. Remove the input speed sensor (3).
  5. Remove the 3 input speed sensor seals (1).
Installation Procedure

    Install the 3 input speed sensor seals (1).
  1. Install the 3 input speed sensor seals (1).
  2. Install the input speed sensor (3).
  3. Verify that the retaining tabs are locked completely.

    4. Caution:

    Refer to Fastener Caution.

  4. Install the input speed sensor bolt (2) M6 x 23 and tighten to 9 Y (80 lb in)

    .

  5. Install the control solenoid valve and transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement.
  6. Perform the transmission adaptive values learn procedure. Refer to Transmission Adaptive Values Learn.
Input Shaft Support Replacement (Gen 2)
Input Shaft Support Replacement Callout Component Name 1 3-5 Reverse and 4-5-6 Clutch Fluid Seals (Qty: 3) ...

Input and Output Speed Sensor Installation
Input and Output Speed Sensor Installation Callout Component Name 1 Input Speed Sensor Assembly Seals 2 ...

Other materials:

Turn Signal Multifunction Switch Replacement
.. Turn Signal Multifunction Switch Replacement Callout Component Name Preliminary Procedure Remove the upper trim cover and the lower trim cover from the steering column. Refer to Steering Column Lower Trim Cover Replacemen ...

Hood Primary and Secondary Latch Replacement
Hood Primary and Secondary Latch Replacement Callout Component Name 1 Hood Primary and Secondary Latch Bolt (Qty:?€‰2) Caution: Refer to Fastener Caution. Tighten 22?€‰Y (16?€‰lb?€‰ft) ...

Crankshaft Front Oil Seal Replacement
Special Tools EN-960 Installer EN-45000 Remover Oil seal For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the crankshaft balancer. Refer to Crankshaft Balancer Replacement. Place a drain pan underneath the front crankshaft seal area. ...

© 2014-2026 Copyright www.csmans.com
 
0.0068