Chevrolet Sonic Repair Manual: Inspection/Maintenance (I/M) System DTC Table

Chevrolet Sonic Repair Manual / Powertrain / Internal Combustion Powertrain Control / Engine Control / General / Inspection/Maintenance (I/M) System DTC Table

Inspection/Maintenance (I/M) System DTC Table
System	DTCs Required to Set System Status to YES
If an inspection/maintenance system status indicator did not update to yes during the Inspection/Maintenance Complete System Set Procedure, review each indicator and reference this table to determine each DTC associated with the inspection/maintenance system status indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the conditions for running for each DTC listed below will allow the inspection/maintenance system status indicators to transition to yes.
Catalyst monitor	DTC P0420.
EGR/CMP	DTC P0011 or P0014.
Evaporative emission (EVAP)	DTC P0442 DTC P0446 DTC P0455
Fuel System	DTC P219A.
Oxygen sensor	DTC P0131, P0132, P0134, P0137, P0138, or P0140. Refer to DTC P0131, P0132, P0134, P0137, P0138, or P0140. DTC P0133, P013A, P013B, P013E, P013F, P015A, P015B, P2270, or P2271. Refer to DTC P0133, P013A, P013B, P013E, P013F, P015A, P015B, P2270, or P2271.
Oxygen sensor heater	DTC P0030?0032, P0036?0038, P0053, P0054, P0135, or P0141. Refer to DTC P0030-P0032, P0036-P0038, P0053, P0054, P0135, or P0141.

Ignition Coil Replacement

Special Tools EN-6009 Remover and Installer Ignition Coil For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the engine wiring harness guide ...

Inspection/Maintenance (I/M) System DTC Table (LUW)

Inspection/Maintenance (I/M) System DTC Table System DTCs Required to Set System Status to YES If an inspection/maintenance system stat ...

Other materials:

Drum Brake Adjusting Hardware Inspection
Warning: Refer to Brake Dust Warning. Visually inspect the adjuster actuator spring (1) for the following conditions: Excessive stretching Excessive bending Excessive corrosion Broken Missing If any of the conditions listed were found, the adjuster actu ...

Inspection/Maintenance Complete System Set Procedure
Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic cat ...

Transmission Fluid Pump Assemble (6T30)
Table 1: Fluid Pump w/Valve Trains Assemble Table 2: Torque Converter Fluid Seal and Fluid Filter Assembly Assemble Fluid Pump w/Valve Trains Assemble Fluid Pump w/Valve Trains Assemble Callout Comp ...

0.0081