System |
DTCs Required to Set System Status to YES |
---|---|
If an inspection/maintenance system status indicator did NOT update to YES during the Inspection/Maintenance System Check, review each indicator and reference this table to determine each DTC associated with the inspection/maintenance system status indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the conditions for running for each DTC listed below will allow the inspection/maintenance system status indicators to transition to YES. |
|
Catalyst Monitor |
DTC P0420 |
Evaporative emission (EVAP) |
|
Fuel System |
DTC P219A |
Oxygen sensor |
|
Oxygen sensor heater |
DTC P0030-P0032, P0036-P0038, P0053, P0054, P0135, or P0141 |
Camshaft System |
DTC P0011 or P0014 |
Electronic Brake Control Module Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Remove the battery tray. Refer to Battery Tray Replacement.
Disconnect the electronic brake control module (EBC ...
Communication Interface Module Battery Replacement
Communication Interface Module Battery Replacement
Callout
Component Name
Preliminary Procedure
Remove the instrument panel lower compartment. Refer to Instrument Panel
Lower Compartment Replacement
1
...
Range Selector Lever Cable Bracket Replacement
Removal Procedure
Set the park brake and chock the wheels.
Disconnect the range selector cable end (1) from the
range selector lever.
Disconnect the range selector cable (2) from the range
selector cable bracket.
Remove the transmission rang ...