|
System |
DTCs Required to Set System Status to YES |
|---|---|
|
If an inspection/maintenance system status indicator did NOT update to YES during the Inspection/Maintenance System Check, review each indicator and reference this table to determine each DTC associated with the inspection/maintenance system status indicator. Each DTC listed below has specific conditions that must be met for the diagnostic to run. Included within the conditions are additional DTCs which, if set, may inhibit the DTCs listed below from running. Reviewing and operating the vehicle within the conditions for running for each DTC listed below will allow the inspection/maintenance system status indicators to transition to YES. |
|
|
AIR |
|
|
Catalyst Monitor |
DTC P0420 |
|
Evaporative emission (EVAP) |
|
|
Fuel System |
DTC P219A |
|
Oxygen sensor |
|
|
Oxygen sensor heater |
DTC P0030-P0032, P0036-P0038, P0053, P0054, P0135, or P0141 |
|
Camshaft System |
DTC P0011 or P0014 |
Inspection/Maintenance (I/M) System DTC Table (LUW)
Inspection/Maintenance Complete System Set ProcedureSteps for Determining Correct Load Limit
1. Locate the statement "The combined weight of occupants and cargo should never
exceed XXX kg or XXX lbs." on your vehicle’s placard.
2. Determine the combined weight of the driver and passengers that will be riding
in your vehicle.
3. Subtract the combined weight of the driver an ...
Disc Brake System Description and Operation
System Component Description
The disc brake system consists of the following components:
Disc Brake Pads
Applies mechanical output force from the hydraulic brake calipers to
friction surfaces of brake rotors.
Disc Brake Rotors
Uses mechanical output force ap ...
Differential Case Assemble
Special Tools
J-810721 Axle Shaft Seal Remover Support Base
R-0407011 Bearing Race Remover
R-0407012 Differential Carrier Cone Bearing Cap Driver
R-0007761 Universal Handle for Pullers and Installers
S-9407194 Speed Sensor Impeller Ring Installer
S-9407195 Pinion Gear Case Bearing I ...