Chevrolet Sonic Repair Manual: Instrument Panel Center Molding Replacement (With U58)

Chevrolet Sonic Repair Manual / Body / Body Interior / Dashboard Assembly / Instrument Panel Center Molding Replacement (With U58)

Instrument Panel Center Molding Replacement
Callout	Component Name
1	Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90?° to release the top of the molding away from the instrument panel assembly. Grasp the molding with both hands, one on each side of the air outlets, and pull straight back, working from top to bottom. When replacing the center molding assembly, transfer all necessary components.

Instrument Panel Center Air Outlet Replacement

Instrument Panel Center Air Outlet Replacement Callout Component Name Preliminary Procedure Remove the instrument panel center ...

Instrument Panel Center Molding Replacement (Without U58)

Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedu ...

Other materials:

Multi-Axis Acceleration Sensor Module Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia Sensor Module (IMU) is not properly configured with the correct calibration software, the Electronic Brake Control Module will ...

Rear Brake Shield Replacement
Removal Procedure Warning: Refer to Brake Dust Warning. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Remove the rear brake rotor. Refer to R ...

Transmission Assemble (Gen 1)
Special Tools 3-9506289 Universal Adapter R-0007758 Holding Fixture S-9407197 Differential Rotating Tool S-9407198 Differential Bearing Race Wrench For equivalent regional tools, refer to Special Tools. Install the clutch and differential housing assembly (1) onto ...

0.0072