Chevrolet Sonic Repair Manual: Instrument Panel Center Molding Replacement (Without U58)

Chevrolet Sonic Repair Manual / Body / Body Interior / Center Console / Instrument Panel Center Molding Replacement (Without U58)

Instrument Panel Center Molding Replacement
Callout	Component Name
1	Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90?° to release the top of the molding away from the instrument panel assembly. Grasp the molding with both hands, one on each side of the air outlets, and pull straight back, working from top to bottom. When replacing the center molding assembly, transfer all necessary components.

Instrument Panel Center Molding Replacement (With U58)

Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedu ...

Instrument Panel Center Trim Panel Replacement

Instrument Panel Center Trim Panel Replacement Callout Component Name 1 Instrument Panel Center Trim Panel (Qty:?€‰2 ...

Other materials:

Drive Belt Installation
Special Tools EN-955 Locking Pins EN-48488 Holding Wrench For equivalent regional tools, refer to Special Tools. Note: Ensure that the drive belt tensioner is held with EN-955?E locking pin. Install the drive belt. Move the drive belt tensioner clockwise until EN- ...

Inspection/Maintenance (I/M) System DTC Table
Inspection/Maintenance (I/M) System DTC Table System DTCs Required to Set System Status to YES If an inspection/maintenance system status indicator did not update to yes during the Inspection/Maintenance Complete System Set Pro ...

Clutch System Description and Operation
Clutch Spin Down Time Inspect the clutch spin down time as follows: Apply the parking brake and block the vehicle wheels. Shift the manual transmission into NEUTRAL. Start the engine. Run the engine at idle speed. Engage the clutch. Disengage the clutch. Wait 9 seconds. ...

0.0095