Spark Plug Replacement
InformationEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as
indicated on the reservoir cap. See Engine Compartment Overview for the location
of the reservoir.
There are only two reasons why the fluid level in the reservoir might go down:
The fluid level goes down b ...
Master Cylinder Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Place the ignition switch in the OFF position.
Remove the battery. Refer to Battery Replacement.
Disconnect ...