Chevrolet Sonic Repair Manual: Intake Camshaft Replacement
- Removal Procedure
-
- Remove the camshaft intake and exhaust sprocket. Refer to Camshaft Intake and Exhaust Sprocket Replacement.
- Remove the camshaft bearing cap bolts in sequence shown. Ensure to remove the bolts one turn at a time until there is no spring tension pushing on the camshaft.
- Remove the camshaft bearing cap bolts (1).
- Remove the camshaft bearing caps (2).
- Remove the intake camshaft (3).
Note:
Mark the camshafts bearing caps and the camshaft upon removal to ensure installation is in the correct position.
- Installation Procedure
-
- Lubricate the camshaft and camshaft bearing caps with engine oil.
- Install the intake camshaft (3).
- Install the camshaft bearing caps (2).
- Install the camshaft bearing cap bolts and tighten the bolts hand tight (1).
- Install and tighten the camshaft bearing cap bolts one turn at a time
in sequence as shown to 8 Y (71 lb in)
.
- Install the camshaft intake and exhaust sprocket. Refer to Camshaft Intake and Exhaust Sprocket Replacement.
Note:
Ensure that the camshaft sealing rings are in place in the camshaft grooves. Camshaft sealing rings must be in place below the surface of the camshaft journal in order to avoid being pinched between the cylinder head and the camshaft caps.
Caution:
Refer to Fastener Caution.
Intake Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the ...
Camshaft Gears
...
Other materials:
Underbody Rear Side Rail Extension Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Disable the SIR System. Refer to SIR Disabling and Enabling.
Disconnect the negative battery cable. Refer ...
Replacing Safety Belt System Parts after a Crash
Warning: A crash can damage the safety belt system in the vehicle.
A damaged safety belt system may not properly protect the person using it, resulting
in serious injury or even death in a crash. To help make sure the safety belt
systems are working properly after a crash, have them insp ...
Rear Wiper/Washer System Description and Operation
The rear window wiper motor is located inside the hatchback door and is directly
connected to the rear window wiper. Ignition voltage is supplied to the rear wiper
motor through the wiper switch. The hatchback rear window washer systems equipped
with a separate washer fluid pump, hose, and noz ...
0.0062