Chevrolet Sonic Repair Manual: Intake Manifold Disassemble (1.8L LUW and LWE)
- Remove the intake manifold absolute pressure sensor bolt (1).
- Remove the manifold absolute pressure sensor (2) from the intake manifold (3).
- Remove the intake manifold mount (2) from the intake manifold (1).
- Remove the throttle body seal (1).
- Remove the intake manifold seal (3) from the intake manifold (2).
- Remove the 2 evaporative emission canister purge solenoid valve bracket bolts (2).
- Remove the evaporative emission canister purge solenoid valve bracket (1) from the intake manifold (3).
- Remove the 2 multiport fuel injection fuel rail bolts (1).
- Remove the multiport fuel injection fuel rail (2) and the fuel injectors (3) from the intake manifold (5).
- Remove the 4 multiport fuel injector seals (4).
Intake Manifold Disassemble (1.6L LDE)
Remove the intake manifold absolute pressure sensor bolt.
Remove the manifold absolute pressure sensor (1) from the intake manifold (2).
Remove the intake manifold m ...
Intake Manifold Installation
Clean the sealing surfaces.
Install the intake manifold (1) along with a NEW intake manifold gasket.
Caution: Refer to Fastener Caution.
Install the 6 intak ...
Other materials:
Liftgate (Hatchback)
Warning
Exhaust gases can enter the vehicle if it is driven with the liftgate, hatch/trunk
open, or with any objects that pass through the seal between the body and the hatch/trunk
or liftgate. Engine exhaust contains carbon monoxide (CO) which cannot be seen or
smelled. It can cause unconsci ...
Brake Rotor Assembled Lateral Runout Correction
Note:
Brake rotor thickness variation MUST be checked BEFORE checking for
assembled lateral runout (LRO). Thickness variation exceeding the maximum
acceptable level can cause brake pulsation. Refer to Brake Rotor Thickness
Variation Measurement.
Brake rotor assembled latera ...
Radiator Cleaning
Warning: NEVER spray water on a hot heat exchanger. The resulting
steam could cause personal injury.
Caution: The heat exchanger fins are necessary for good heat transfer.
Do not brush the fins. This may cause damage to the fins, reducing heat transfer.
Note: Blow compressed ...
0.0068