Chevrolet Sonic Repair Manual: Intake Manifold Installation (1.6L LDE)
- Clean the sealing surfaces.
- Insert the NEW gasket.
- Install the intake manifold (2) and the 7 intake manifold bolts (1) and
tighten to 20 Y (15 lb ft)
.
- Install the intake manifold support (1) and the 2 bolts (2, 3) and tighten
to 8 Y (71 lb in)
.
Caution:
Refer to Fastener Caution.
Intake Manifold Installation
Clean the sealing surfaces.
Install the intake manifold (1) along with a NEW intake manifold gasket.
Caution: Refer to Fastener Caution.
Install the 6 intak ...
Intake Manifold Installation (1.8L LUW and LWE)
Clean the sealing surfaces.
Install 4 NEW gaskets.
Caution: Refer to Fastener Caution.
Install the intake manifold (2) and the 7 intake manifold bolts (1 ...
Other materials:
Brake Shoe Replacement (J93, J94)
Removal Procedure
Warning: Refer to Brake Dust Warning.
Note: Always replace brake shoes in axle sets.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and In ...
Master Cylinder Reservoir Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Remove the brake master cylinder. Refer to Master Cylinder Replacement.
Remove and discard the b ...
Secondary Air Injection System Description
The Secondary Air Injection System aids in the reduction of hydrocarbon exhaust
emissions during a cold start. This occurs when the start-up engine coolant temperature
(ECT) is between −10 to +56°C (14?E33°F), the intake air temperature (IAT) is greater
than −10°C (14°F) and it ...
0.007