|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Properly raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. |
|
|
1 |
Intake Manifold Runner Control Valve Actuator Solenoid Valve Fastener (Qty: 3) Caution: Refer to Fastener Caution.
6 Y (53 lb in) |
|
2 |
Intake Manifold Runner Control Valve Actuator Solenoid Linkage |
|
3 |
Intake Manifold Runner Control Valve Actuator Solenoid Procedure
Disconnect the wiring harness electrical connector from the intake manifold runner control valve actuator solenoid. |
Throttle/Idle LearnWheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
Remove the wheel drive shaft tripod housi ...
Turbocharger Assemble
Caution: Refer to Fastener Caution.
Install the NEW quick fitting connector (2) and a NEW seal ring (1) to the
turbocharger and tighten to 20 Y (15 lb ft).
Inspect the turbocharger coolant pipes for ridges and damage.
Install the tur ...
Exhaust Camshaft Removal
Remove the camshaft bearing cap bolts in a spiral sequence as shown one
turn at a time until there is no spring tension pushing on the camshaft.
Note: Mind the markings on the camshaft bearing caps to ensure
they will be installed in the same position.
Remove the ...