Hydraulic Valve Lash Adjuster Replacement
Engine ControlEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Air Cleaner Element Replacement
Removal Procedure
Disconnect mass air flow sensor wiring harness plug (2) from mass air
flow sensor (3).
Unclip mass air flow sensor wiring harness retainer clip from air cleaner
housing (1).
Remove the air cleaner outlet duct clamp̴ ...
Transmission Case Cleaning and Inspection
Transmission Case Cleaning and Inspection
Callout
Component Name
Caution: Do not use abrasive pads or bristle devices to clean
the sealing surfaces. Abrasive pads produce a fine grit that can effect
transmission func ...