Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Knock Sensor Replacement



Knock Sensor Replacement

Callout

Component Name

Preliminary Procedures

  1. Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Raise and support the vehicle. Refer to  Lifting and Jacking the Vehicle

1

Knock Sensor Bolt

Caution:

Refer to Fastener Caution.

Procedure

  1. Disconnect the electrical connector.
  2. DO NOT mistake the knock sensor electrical connector with the generator electrical connector.
Tighten


25 Y (18 lb ft)

2

Knock Sensor

Evaporator Air Temperature Sensor Replacement (LHD)
Evaporator Air Temperature Sensor Replacement Callout Component Name 1 Evaporator Air Refrigerant Temperature Sensor ...

Knock Sensor System Description
Circuit/System Description The knock sensor system enables the engine control module (ECM) to control the ignition timing for the best possible performance while protecting the engine ...

Other materials:

Radio Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the ECU is not properly configured with the correct calibration software, the ECU will not control all of the vehicle features properly. Ensure the programming tool is ...

Outside Rearview Mirror Housing Replacement
Outside Rearview Mirror Housing Replacement Callout Component Name Preliminary Procedures Remove the outside rearview housing cover. Refer to Outside Rearview Mirror Housing Rear Cover Replacement. Remove the outside rear ...

Parking Brake Cable Replacement (Disc Brake)
Removal Procedure Remove the front floor console. Refer to Front Floor Console Replacement. Ensure that the parking brake lever is in the fully released position. Using ONLY HAND TOOLS, remove the adjusting nut (1) from the end of the front park brake c ...

В© 2014-2025 Copyright www.csmans.com
 
0.0065