Chevrolet Sonic Repair Manual: License Plate Lamp
- Lamp Assembly
- Bulb Assembly
- Bulb Socket
- Bulb
- Lamp Assembly
To replace one of these bulbs:
- Push the left end of the lamp assembly toward the right.
- Turn the lamp assembly down to remove it.
- Turn the bulb socket (1) counterclockwise to remove it from the lamp assembly (3).
- Pull the bulb (2) straight out of the bulb socket (1).
- Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install it into the lamp assembly.
- Turn the lamp assembly into the lamp assembly opening engaging the clip side first.
- Push on the lamp side opposite the clip until the lamp assembly snaps into place.
Headlamps, Front Turn Signal and Parking Lamps
Passenger Side Shown, Driver Side Similar
High-Beam Headlamp
Low-Beam Headlamp
Parking/Turn Signal Lamps
High-Beam Headlamp/Low-Beam Headlamp
Open the hood. See Hood.
For ...
Parking and Turn Signal Lamp Bulb Replacement
Parking and Turn Signal Lamp Bulb Replacement
Callout
Component Name
Preliminary Procedures
Open and support the hood assembly.
...
Other materials:
Rear Side Door Adjustment (4 Door Notch Back 69)
Rear Side Door Adjustment
Callout
Component Name
1
Rear Side Door
Caution: Refer to Fastener Caution.
Procedure
Loosen the rear door hinge bolt?€‰(Qty:?€‰4) to adjust the rear
door.
A ...
Crankshaft Position System Variation Learn
Note: The crankshaft position sensor system variation learn procedure
is required when the following service procedures have been performed, regardless
of whether DTC P0315 is set:
Engine replacement
Engine control module (ECM) replacement
Crankshaft damper replacement
...
Cylinder Head Installation
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces.
Inspect for plane surface.
Cylinder block, cylinder head
Straight-edge, feeler gauge
Install the cylinder head gasket.
Install the cylinder head. ...
0.0063