Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Liftgate Adjustment



Liftgate Adjustment

Callout

Component Name

1

Liftgate

Caution:

Refer to Fastener Caution.

Procedure

  1. Loosen the 4 liftgate hinge bolts to adjust the liftgate.
  2. Adjust the liftgate in order to obtain an even gap between the liftgate and the roof, the quarter outer panel, the tail lamp and rear bumper fascia and so that the liftgate is flush with the roof, the quarter outer panel, the tail lamp and rear bumper fascia.
Adjustment:

  • Liftgate to roof?€‰(a) 5.5?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.22?€‰in?€‰?±?€‰0.04?€‰in)
  • Liftgate to quarter outer panel?€‰(b) 4.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.16?€‰in?€‰?±?€‰0.04?€‰in)
  • Liftgate to tail lamp?€‰(c) 3.5?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.14?€‰in?€‰?±?€‰0.04?€‰in)
  • Liftgate to rear bumper fascia?€‰(d) 5.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.20?€‰in?€‰?±?€‰0.04?€‰in)
Tighten


22?€‰Y (16?€‰lb?€‰ft)

Hood Side Seal Replacement
Hood Side Seal Replacement Callout Component Name 1 Hood Side Seal Push-In Retainer (Qty:?€‰6) 2 ...

Liftgate Hinge Replacement
Liftgate Hinge Replacement Callout Component Name Preliminary Procedures Remove the liftgate. Refer to Liftgate Replacement. L ...

Other materials:

Lane Departure Warning (LDW) Light
This light comes on briefly while starting the vehicle. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the light then turns off. This light comes on green when the system is on and ready to operate. When the system determines that the vehicle is ...

Air Inlet Grille Panel Replacement
Air Inlet Grille Panel Replacement Callout Component Name Preliminary Procedure Remove both wiper arm assemblies. Refer to Windshield Wiper Arm Replacement. Remove both outer hood rear seals. Refer to Hood Rear Seal Repla ...

Adhesive Installation of Rear Windows
Warning: Refer to Glass and Sheet Metal Handling Warning. Use a urethane adhesive systems which meet GM Specification GM?€‰3651G. Remove all mounds or loose pieces of urethane adhesive from the pinchweld area. If the original window is being reused, remove all but approxi ...

© 2014-2025 Copyright www.csmans.com
 
0.0057