Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Liftgate Emblem/Nameplate Replacement (Hatchback)

Chevrolet Sonic Repair Manual / Body / Body Exterior / Identification Plates / Liftgate Emblem/Nameplate Replacement (Hatchback)



Liftgate Emblem/Nameplate Replacement

Callout

Component Name

1

Liftgate Emblem/Nameplate Assembly

Caution:

Refer to Exterior Trim Emblem Removal Caution.

Procedure

  1. The part and surface should be 21?°C (70?°F) prior to installation. The vehicle should remain 21?°C (70?°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
  2. Use a Heat Gun or equivalent to remove the old nameplate. Clean all adhesive from the liftgate panel and wipe the surface dry with a clean lint-free towel prior to installing the new nameplate.
  3. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
  4. Using the previous witness marks of the old emblem/nameplate or making measurements from another alike vehicle, use masking tape to reference the alignment of the new emblem/nameplate to the liftgate panel.
  5. Close the rear liftgate panel prior to adhesion.
  6. Using the palm of the hand, wet out the emblem/nameplate to the rear liftgate panel to ensure full adhesion of the emblem is made.
Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution. The part and vehicle surface should be 21?°C (70?°F) prior to installation. The vehicle should remain inside in a temperature ...

Radiator Grille Emblem/Nameplate Replacement
Radiator Grille Emblem/Nameplate Replacement Callout Component Name Preliminary Procedure Remove the front bumper fascia. Refer to ...

Other materials:

Rear Wheelhouse Panel Liner Extension Replacement
Rear Wheelhouse Panel Liner Extension Replacement Callout Component Name Preliminary Procedure Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. 1 Rear Wheelh ...

Power Windows Description and Operation
Power Window System Components The power window system consists of the following components: Driver window switch Front passenger window switch Left rear window switch Right rear window switch Window regulator motors in each of the doors Body control module ...

Torque Converter Housing with Fluid Pump Assembly Installation (6T30)
Torque Converter Housing with Fluid Pump Assembly Installation Callout Component Name 1 Fluid Pump Seal Assembly 2 Torque Converter Housing Gasket 3 Torque Converte ...

© 2014-2024 Copyright www.csmans.com
 
0.0062