Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Liftgate Hinge Replacement



Liftgate Hinge Replacement

Callout

Component Name

Preliminary Procedures

  1. Remove the liftgate. Refer to Liftgate Replacement.
  2. Lower the rear of the headliner to access the inner bolts. Refer to Headlining Trim Panel Replacement.
  3. Use a grease pencil to mark the liftgate hinge position to the body prior to removal.

1

Liftgate Hinge Nut (Qty:?€‰2)

Caution:

Refer to Fastener Caution.

Tighten


43?€‰Y (32?€‰lb?€‰ft)

2

Liftgate Hinge (Qty:?€‰2)

Procedure

Adjust the liftgate if needed.

Liftgate Window Replacement
Special Tools BO-24402-A Glass Sealant Remover (Cold Knife) BO-39032 Stationary Glass Removal Tool Use an adhesive that is approved by GM For equivalent regional tools, refer to Special Too ...

Body Exterior
...

Other materials:

Replacement Bulbs
Exterior Lamp Bulb Number Back-Up Lamp 921 Front Fog Lamp H8 Front Parking/Turn Signal Lamp 7444NA High-Beam Headlamp 9005LL ...

Multi-Axis Acceleration Sensor Module Programming and Setup
Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia Sensor Module (IMU) is not properly configured with the correct calibration software, the Electronic Brake Control Module will ...

Front Floor Console Cover Replacement (Manual Transmission)
Removal Procedure Use a flat bladed plastic trim tool in order to release the retainers securing the console cover (1) to the console assembly. Reach under the console cover assembly (1) and release the retainer tabs securing the transmission s ...

© 2014-2025 Copyright www.csmans.com
 
0.0066