Chevrolet Sonic Owner's Manual: Lockout Protection

Chevrolet Sonic Owner's Manual / Keys, Doors, and Windows / Keys and Locks / Lockout Protection

If the driver side power door lock switch is pressed when the driver door is open and the key is in the ignition, all of the doors will lock and then the driver door will unlock.

If Unlocked Door Anti Lockout is turned on and: the vehicle is off, the driver door is open, and door locking is requested using a door lock switch or the RKE transmitter, all the doors will lock and only the driver door will unlock.

The Unlocked Door Anti Lockout feature can be turned on or off using the vehicle personalization menus. See Vehicle Personalization.

Lockout Protection can be manually overridden with the driver door open by pressing and holding Safety Locks on the power door lock switch.

Automatic Door Locks

The vehicle is programmed so that when the doors are closed, the ignition is on, and the shift lever is moved out of P (Park) for automatic transmissions, or when the vehicle speed is above 13 km/ ...

Safety Locks

The rear door safety locks prevent passengers from opening the rear doors from inside the vehicle. Manual Safety Locks If equipped, the safety lock is located on the inside edge of the rear door ...

Other materials:

Liftgate Window Replacement
Special Tools BO-24402-A Glass Sealant Remover (Cold Knife) BO-39032 Stationary Glass Removal Tool Use an adhesive that is approved by GM For equivalent regional tools, refer to Special Tools Removal Procedure Warning: Refer to Cracked Window Warning. Note ...

Stabilizer Shaft Replacement
Removal Procedure Remove the intermediate steering shaft lower bolt. Refer to Intermediate Steering Shaft Replacement. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Inst ...

Automatic Transmission Flex Plate Removal
Special Tools EN-652 Automatic Transmission Flex Plate Holder For equivalent regional tools, refer to Special Tools. Install the EN-652 holder (1) to hold the automatic transmission flex plate (2). Loosen the 6 automatic transmission flex plate bolts. Re ...

0.0076