Locks are lubricated at the factory. Use a de-icing agent only when absolutely necessary, and have the locks greased after using. See Recommended Fluids and Lubricants.
Exterior Care
Washing the VehicleEngine Heater
The engine heater can provide easier starting and better fuel economy during
engine warm-up in cold weather conditions at or below −18°C (0°F). Vehicles with
an engine heater should be plugged in at least four hours before starting.
1. Turn off the engine.
2. Open the hood and unwrap ...
Radiator Cleaning
Warning: NEVER spray water on a hot heat exchanger. The resulting
steam could cause personal injury.
Caution: The heat exchanger fins are necessary for good heat transfer.
Do not brush the fins. This may cause damage to the fins, reducing heat transfer.
Note: Blow compressed ...
Camshaft Position Actuator Adjuster Removal
Special Tools
EN-6340 Camshaft Adjuster Locking Tool
EN-6628-A Camshaft Locking Tool
For equivalent regional tools, refer to Special Tools.
Note: The right half of the EN-6340 locking tool can be
recognized by the lettering "right", arrow, on the tool.
Pre ...