Callout |
Component Name |
---|---|
1 |
Low and Reverse and 1??? Clutch Housing Note: The longer legs face the bottom of the case and the oil passages face the valve body end of the case. |
2 |
Output Sun Gear Assembly |
3 |
1??? Clutch Waved Plate Note: Align the single pair of tabs with the bottom valve body end of the case. |
4 |
1??? Clutch Plate (Qty: 2) |
5 |
1??? Clutch Plate Assembly (Qty: 2) |
6 |
1??? Clutch Backing Plate Note: Align the single tab with the case spline facing the bottom of the case. |
7 |
1??? Clutch Backing Plate Retainer Ring Warning: The retainer is under tension. Use care when removing or installing the retainer. Personal injury could result. Caution: Use caution during removal or installation of the retainer ring to avoid damage to the case machined surface in the park pawl area. Burrs or raised edges on the case machined surface can cause the park pawl to bind and prohibit it from engaging the park gear. Note:
Special Tool
DT-28585 Snap Ring Remover or equivalent For equivalent regional tools, refer to Special Tools. |
California Fuel Requirements
If the vehicle is certified to meet California Emissions Standards, it is designed
to operate on fuels that meet California specifications. See the underhood emission
control label. If this fuel is not available in states adopting California Emissions
Standards, the vehicle will operate satisf ...
Rear Side Door Window Rear Guide Replacement
Rear Side Door Window Rear Guide Replacement
Callout
Component Name
Preliminary Procedure
Remove the rear side door trim panel. Refer to Rear Side Door Trim Replacement.
1
Rear Side Door Window R ...
Engine Oil Cooler Removal
Remove the oil cooler coolant outlet hose clamp (1).
Remove the oil cooler coolant outlet hose (2) from engine coolant thermostat
housing.
Remove the oil cooler coolant inlet hose clamp (3).
Remove the oil cooler coolant inlet hose (4) from water outlet. ...