Chevrolet Sonic Repair Manual: Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Transmission Oil Cooler / Transmission Unit / Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation

Low and Reverse Clutch Assembly and Low and Reverse Clutch Plate Installation
Callout	Component Name
1	Low and Reverse Clutch Assembly (OWC) Note: The Low and Reverse Clutch Assembly should rotate freely in one direction and lock in the opposite direction. With the valve body face at the 6 o?lock position, align the large flat areas of the low and reverse clutch assembly between the 2 o?lock and 5 o?lock position.
2	Low and Reverse Clutch Backing Plate
3	Low and Reverse Clutch Plate Assembly (Qty: 3)
4	Low and Reverse Clutch Plate (Qty: 3) Note: With the valve body face at the 6 o?lock position, align the large flat areas of the low and reverse clutch plate between the 2 o?lock and 5 o?lock position.
5	Low and Reverse Clutch Apply (Waved) Plate Note: With the valve body face at the 6 o?lock position, align the large flat areas of the low and reverse clutch apply plate between the 2 o?lock and 5 o?lock position. Ensure the correct waved plate is being installed. The 1??? clutch and low and reverse clutch waved plates are visually similar, however the low and reverse clutch waved plate is thicker.

Low and Reverse and 1-2-3-4 Clutch Housing, and 1-2-3-4 Clutch Plate Installation (6T40/45/50)

Low and Reverse and 1-2-3-4 Clutch Housing, and 1-2-3-4 Clutch Plate Installation Callout Component Name 1 Low and Re ...

Low and Reverse and 1-2-3-4 Clutch Housing, Low and Reverse Clutch Assembly, Output Sun Gear, and 2-6 Clutch Plate Disassemble (Gen 1)

Low and Reverse and 1-2-3-4 Clutch Housing, Low and Reverse Clutch Assembly, Output Sun Gear, and 2-6 Clutch Plate Disassemble Callout Component Name ...

Other materials:

Hood Rear Weatherstrip Replacement
in Hood Rear Weatherstrip Replacement Callout Component Name 1 Hood Rear Weatherstrip Procedure The hood rear weatherstrip is held in place with 10?€‰plastic retainers that are part of the air inlet grille. ...

Engine Coolant Temperature Sensor Replacement - Radiator
Engine Coolant Temperature Sensor Replacement - Radiator Callout Component Name Preliminary Procedure Drain the cooling system. Refer to Cooling System Draining and Filling. Remove the right front wheelhouse liner. Ref ...

Engine Replacement (Manual Transmission)
Special Tools J-45859 Wheel Drive Shaft Remover . CH-807 Closure Plugs . For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the battery and battery tray. Refer to Battery Tray Replacement. Relieve the fuel system pressure. Refer to ...

0.009