Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Removal

Chevrolet Sonic Repair Manual / Powertrain / Transmission/Transaxle / Automatic / General / Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Removal

Table 1: Manual Shaft Detent (w/Shift Position Switch) Lever Assembly Removal
Table 2: Park Pawl Actuator Guide Removal
Manual Shaft Detent (w/Shift Position Switch) Lever Assembly Removal


Manual Shaft Detent (w/Shift Position Switch) Lever Assembly Removal

Callout

Component Name

1

Manual Shaft Detent Lever Hub Pin

Note:

Use side cutter to remove the pin (1) and discard.

2

Manual Shift Shaft Pin

Note:

Discard the pin. It is not reusable.

Special Tools

  • DT-23129 Universal Seal Remover
  • GE-6125-1B Slide Hammer

For equivalent regional tools, refer to Special Tools.

3

Manual Shaft

4

Manual Shaft Detent (w/Shift Position Switch) Lever Assembly

5

Park Pawl Actuator Assembly

Park Pawl Actuator Guide Removal


Park Pawl Actuator Guide Removal

Callout

Component Name

1

Park Pawl Actuator Guide Pin

Note:

Use side cutter to remove the pin (1) and discard.

2

Park Pawl Actuator Guide Assembly

3

Park Pawl Actuator Guide Assembly Seal

Note:

Discard the seal. It is not reusable.

Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Installation
Table 1: Park Pawl Actuator Guide Installation Table 2: Park Pawl Actuator Installation Park Pawl Actuator Guide Installation Park Pawl Actuator Guide I ...

Manual Shift Shaft Seal Installation
Manual Shift Shaft Seal Installation Callout Component Name 1 Manual Shift Shaft Seal Special Tool DT-49101 Seal ...

Other materials:

Instrument Panel Tie Bar Replacement
Removal Procedure Remove the Instrument panel assembly. Refer to Instrument Panel Assembly Replacement. Remove the steering column and wheel from the vehicle. Refer to Steering Column Replacement. Remove the air inlet grill panel. Refer to Air Inlet Grille Panel Replacem ...

Steering Gear Boot Replacement
Special Tools CH-804  Tensioner For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Rep ...

Air Conditioning System Seal Replacement
Removal Procedure Disassemble the A/C refrigerant components. Refer to the appropriate repair procedure. Note: Cap or tape the open A/C refrigerant components immediately to prevent system contamination. Cap or tape the A/C refrigerant components. ...

В© 2014-2025 Copyright www.csmans.com
 
0.0055