The shift lever should be in Neutral and the parking brake engaged. Hold the clutch pedal to the floor and start the engine. The vehicle will not start if the clutch pedal is not all the way down.
Automatic Transmission
Starting ProcedureDrum Brake Adjusting Hardware Inspection
Warning: Refer to Brake Dust Warning.
Visually inspect the adjuster actuator spring (1) for the following conditions:
Excessive stretching
Excessive bending
Excessive corrosion
Broken
Missing
If any of the conditions listed were found, the adjuster actu ...
Wheel Drive Shaft Outer Joint Inspection
Disassembly Procedure
Remove the outer constant velocity (CV) joint and boot from the wheel
drive shaft. Refer to Front Wheel Drive Shaft Outer Joint and Boot Replacement.
Remove any lubricant from the CV joint.
Note: Position the cage and the inner race so they a ...
Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl
Actuator Removal
Table 1:
Manual Shaft Detent (w/Shift Position Switch) Lever
Assembly Removal
Table 2:
Park Pawl Actuator Guide Removal
Manual Shaft Detent (w/Shift Position
Switch) Lever Assembly Removal
Manual Shaft Detent (w/Shift Position Switch) Lever Assemb ...