Chevrolet Sonic Repair Manual: Manual Transmission Shift Lever and Selector Lever Cable Replacement
- Removal Procedure
-
- Remove the battery tray. Refer to Battery Tray Replacement.
- Disconnect the shift lever and selector lever cable end (1) from the transmission shift lever and selector lever.
- Pull the cable retainers (2) to release the shift lever and selector lever cable from the shift lever and selector lever cable bracket.
- Disconnect the shift lever and selector lever cable from the shift lever and selector lever cable bracket.
- Remove the floor console. Refer to Front Floor Console Replacement.
- Move the floor carpet in order to get access to the shift lever and selector lever cable grommet (1).
- Remove the grommet fasteners (2).
- Lift both cable adjustment retainers (1), one for each cable, to release the shift lever and selector lever cable.
- Pull the shift lever and the selector lever cable retainers (1) from the transmission control assembly (3), then remove the shift lever and selector lever cable from the shift and selector control.
- Pull the shift lever and the selector lever cable assembly through the cowl into the passenger compartment.
- Remove the shift lever and the selector lever cable assembly from the vehicle.
.1
- Installation Procedure
-
- Position the shift lever and the selector lever cable assembly in the vehicle.
- Gently pull the shift lever and the selector lever cable assembly through the cowl into the engine compartment.
- Connect the shift lever and the selector lever cable ends (1) to the transmission shift lever and the selector lever.
- Install the shift lever and the selector lever cable to the shift lever and the selector lever cable bracket.
- Move the floor carpet in order to get access to the shift lever and selector lever cable grommet (1).
- Install the grommet fasteners (2) and tighten to
9 Y (80 lb in)
.
- Connect the shift lever and selector lever cables to the shift and selector control adjusters (2).
- Install the shift lever and selector lever cable retainers (1) to the transmission control (3).
- Press down and lock both cable adjustment retainers (1), one for each cable, to adjust the shift lever and selector lever cable.
- Adjust the shift lever and selector lever cables. Refer to Manual Transmission Shift Lever and Selector Lever Cable Adjustment.
- Install the floor console. Refer to Front Floor Console Replacement.
- Install the battery tray. Refer to Battery Tray Replacement.
- Verify correct operation of the transmission control assembly.
Caution:
Refer to Fastener Caution.
.1
Manual Transmission Shift Lever and Selector Lever Cable Replacement
Removal Procedure
Remove the battery tray. Refer to
Battery Tray Replacement.
\i
Disconnect the shift lever and selector cable ends (1)
from the transmission s ...
Selector and Shift Lever Cable Bracket Replacement
Removal Procedure
Remove the battery tray. Refer to
Battery Tray Replacement.
Disconnect the shift lever and selector lever cable
end (1) from the transmissio ...
Other materials:
Towing the Vehicle
Caution
Incorrectly towing a disabled vehicle may cause damage. The damage would not
be covered by the vehicle warranty. Do not lash or hook to the chassis components
— including the front and rear subframes, suspension control arms, and links — during
towing and recovery of a disabled ve ...
Hood Primary Latch Release Cable Replacement
iv
Hood Primary Latch Release Cable Replacement
Callout
Component Name
Preliminary Procedures
Remove the radiator opening upper cover. Refer to Front Opening
Upper Cover Replacement.
Remove the air inlet grille. Refer to A ...
Input Shaft Assemble
Special Tools
J-840733 Driver
For equivalent regional tools, refer to Special Tools.
Note: Ensure the input shaft rear bearing retaining ring (2) is
placed on the input shaft before installing the input shaft rear bearing
assembly (1).
Place the input sh ...
0.0083