Special Tools
DT-527-A Adjuster or 5mm drill bit
For equivalent regional tools, refer to Special Tools.
Note:
Not using the specified tools may lead to shift system mis-adjustment.
Note:
The hole of the transmission gear control (2) must be aligned to the hole in the base so the pin (1) can pass thru both. The transmission gear control will be locked in the 1? neutral position.
Note:
During this procedure DO NOT touch or preload the fixed shift lever as this may cause mis-adjustment to the shift system.
Manual Transmission Shift Lever and Selector Lever Cable AdjustmentInstrument Panel Center Trim Panel Replacement
Instrument Panel Center Trim Panel Replacement
Callout
Component Name
1
Instrument Panel Center Trim Panel (Qty:?€‰2)
Procedure
Use a flat bladed plastic trim tool in order to disengage the retainers
secur ...
Air Conditioning Evaporator Thermal Expansion Valve Replacement
Air Conditioning Evaporator Thermal Expansion Valve Replacement
Callout
Component Name
Preliminary Procedure
Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
Remove the air conditioning evaporator hos ...
Transmission Indicators and Messages
The following transmission-related indicators and messages may be displayed on
the Instrument Panel Cluster (IPC). For a complete listing and description of all
vehicle indicators and messages, refer to Indicator/Warning
Message Description and Operation.
"TRANSMISSION HOT IDLE ...