Chevrolet Sonic Repair Manual: Master Cylinder Reservoir Filling
Warning:
Refer to Brake Fluid Irritant Warning.
Caution:
Refer to Brake Fluid Effects on Paint and Electrical Components Caution.
- Visually inspect the brake fluid level through the brake master cylinder reservoir.
- If the brake fluid level is at or below the half-full point during routine fluid checks, the brake system should be inspected for wear and possible brake fluid leaks.
- If the brake fluid level is at or below the half-full point during routine fluid checks, and an inspection of the brake system did not reveal wear or brake fluid leaks, the brake fluid may be topped-off up to the maximum-fill level.
- If brake system service was just completed, the brake fluid may be topped-off up to the maximum-fill level.
- If the brake fluid level is above the half-full point, adding brake fluid is not recommended under normal conditions.
- If brake fluid is to be added to the master cylinder reservoir, clean the outside of the reservoir on and around the reservoir cap prior to removing the cap and diaphragm. Use only GM approved brake fluid from a clean, sealed brake fluid container.
Hydraulic Brake System Flushing
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components
Caution.
Inspect the brake fluid for the following conditio ...
Master Cylinder Reservoir Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical
Components Caution.
Remove the brak ...
Other materials:
Front Floor Console Cup Holder Replacement
Front Floor Console Cup Holder Replacement
Callout
Component Name
Preliminary Procedure
Remove the front floor console assembly. Refer to Front Floor Console
Replacement.
1
Front Floor Console C ...
Turbocharger Installation
Special Tool
EN-49942 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces.
Replace the connect fittings on the turbocharger coolant feed pipe and the
turbocharger coolant return pipe. Refer to Turbocharger Disassemble and Turbocharger
Ass ...
Intake Manifold Installation (1.6L LDE)
Clean the sealing surfaces.
Insert the NEW gasket.
Caution: Refer to Fastener Caution.
Install the intake manifold (2) and the 7 intake manifold bolts (1) and
tighten to 20 Y (15 lb ft).
Install the intake manifold supp ...
0.0053