Chevrolet Sonic Repair Manual: Master Cylinder Reservoir Replacement
- Removal Procedure
-
Warning:
Refer to Brake Fluid Irritant Warning.
Caution:
Refer to Brake Fluid Effects on Paint and Electrical Components Caution.
- Remove the brake master cylinder. Refer to Master Cylinder Replacement.
- Remove and discard the brake master cylinder reservoir roll pin (1).
- Remove the master cylinder reservoir (1) by carefully pulling straight upward.
- Remove the brake fluid level indicator switch, if necessary. Refer to Brake Fluid Level Indicator Switch Replacement.
- Remove the brake master cylinder reservoir seals (1).
- If replacing the master cylinder reservoir, discard the reservoir seals.
- Installation Procedure
-
- Lightly lubricate the brake master cylinder reservoir seals (1) with GM approved brake fluid from a clean, sealed, brake fluid container.
- Install the lubricated brake master cylinder reservoir seals to the brake master cylinder.
- Install the master cylinder reservoir (1) by firmly pressing straight downward.
- Install the brake fluid level indicator switch, if removed. Refer to Brake Fluid Level Indicator Switch Replacement.
- Install a new brake master cylinder reservoir roll pin (1).
- Install the brake master cylinder. Refer to Master Cylinder Replacement.
Master Cylinder Reservoir Filling
Warning: Refer to Brake Fluid Irritant Warning.
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components
Caution.
Visually inspect the brake fluid level through the ...
Front Brake Hose Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning.
Warning: Refer to Brake Fluid Irritant Warning.
Danger: Do not use a service jack to lift this vehicle. Li ...
Other materials:
Evaporative Emission Canister Replacement (Steel Tank)
Removal Procedure
Remove the evaporative emission canister bracket fasteners (1).
Disconnect the purge solenoid valve electrical connector (1).
Disconnect the evaporative emission canister vent hose (2).
Disconnect the evaporative emission c ...
Engine Coolant Temperature Sensor Replacement (Radiator)
Engine Coolant Temperature Sensor Replacement - Radiator
Callout
Component Name
Preliminary Procedures
Drain the cooling system. Refer to Cooling System
Draining and Filling.
1
Retaining ...
Input Shaft Assemble
Special Tools
J-840733 Driver
For equivalent regional tools, refer to Special Tools.
Note: Ensure the input shaft rear bearing retaining ring (2) is
placed on the input shaft before installing the input shaft rear bearing
assembly (1).
Place the input sh ...
0.0084