Chevrolet Sonic Repair Manual: Metric Wheel Nuts and Bolts Description
Metric wheel/nuts and bolts are identified in the following way:
- The wheel/nut has the word Metric stamped on the face.
- The letter M is stamped on the end of the wheel bolt.
The thread sizes of metric wheel/nuts and the bolts are indicated by the following example: M12 x 1.5.
- M = Metric
- 12 = Diameter in millimeters
- 1.5 = Millimeters gap per thread
General Description
The factory installed tires are designed to operate satisfactorily with loads
up to and including the full rated load capacity when these tires are inflated to
the recommended pressures.
The fol ...
P-Metric Sized Tires Description
245/50r16953typeloadindep-passengerttemporarylt-lighttruckspeedsymbolsectionwidth(millimeters)235245275construction(sectionwidth)ddagonal(bas)40sectionwidthsectionheight
Replacement tires should be ...
Other materials:
Air Inlet Grille Panel Replacement
Air Inlet Grille Panel Replacement
Callout
Component Name
Preliminary Procedure
Remove both wiper arm assemblies. Refer to Windshield Wiper Arm
Replacement.
Remove both outer hood rear seals. Refer to Hood Rear Seal Repla ...
Drive Range - Fourth Gear (Gen 1)
As vehicle speed increases, the transmission control module (TCM) processes input
signals from the automatic transmission input and output speed sensors, the throttle
position sensor and other vehicle sensors to determine the precise moment to command
OFF the normally-high 35R pressure control ...
Reverse (Gen 2)
When the gear selector lever is moved to the Reverse (R) position (from the Park
position) the normally-low 35R pressure control solenoid is commanded ON and the
following changes occur in the transmission? hydraulic and electrical systems:
3-5-Reverse Clutch Applies
Manual Valve
...
0.0061