|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the generator. Refer to Generator Replacement. |
|
|
1 |
Oil Flow Check Valve Bore Plug Caution: Refer to Fastener Caution.
21 Y (16 lb ft) |
|
2 |
Oil Flow Check Valve |
Oil Lines
Oil PumpEmblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Air Conditioning (AC) Refrigerant Filter Replacement
Special Tools
GE 39400-A Halogen Leak Detector
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
Remove the air conditioning condenser. Refer to Air Conditioning Condenser
Repl ...
Engine Replacement (Automatic Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover
CH-807 Closure Plugs
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and battery tray. Refer to Battery Tray Replacement.
Relieve the fuel system pressure. Refer to Fuel Pressur ...