Chevrolet Sonic Repair Manual: Oil Level Indicator and Tube Installation
- Install a NEW oil level indicator tube gasket.
- Install the oil level indicator tube (2).
- Install the oil level indicator tube bolt (1) and tighten to 15 Y (11 lb ft)
.
- Install the oil dipstick.
Caution:
Refer to Fastener Caution.
Oil Level Indicator Tube Replacement
Removal Procedure
Note: If the engine oil level is at maximum, some oil may
emerge when drawing out the oil dipstick guide tube.
Place collecting basin underneath.
...
Oil Level Indicator and Tube Removal
Remove the oil dipstick.
Remove the oil level indicator tube bolt (1).
Note: If the engine oil level is at the maximum level, oil may
emerge while removing the oil dipstick ...
Other materials:
Protecting Exterior Bright Metal Moldings
Caution
Failure to clean and protect the bright metal moldings can result in a hazy
white finish or pitting. This damage would not be covered by the vehicle warranty.
The bright metal moldings on the vehicle are aluminum. To prevent damage always
follow these cleaning instructions:
Be sure ...
Radio Antenna Base Replacement
Radio Antenna Base Replacement
Callout
Component Name
Preliminary Procedure
Lower the rear of the headlining trim panel. Refer to
Headlining Trim Panel Replacement.
1
Radio Antenna Base Fastener
...
SIR Disabling and Enabling
SIR component location affects how a vehicle should be serviced. There are parts
of the SIR system installed in various locations around a vehicle. To find the location
of the SIR components refer to Supplemental Inflatable Restraint System Description
and Operation.
There are several reason ...
0.006