Chevrolet Sonic Repair Manual: Oil Level Indicator Tube

Engine Oil and Oil Filter Replacement

Removal Procedure Open hood. Place a drain pan below the vehicle. Caution: To prevent damage to oil filter cap ensure proper tool is used. Do not use an open end wrench wh ...

Oil Level Indicator Tube Replacement

Removal Procedure Note: If the engine oil level is at maximum, some oil may emerge when drawing out the oil dipstick guide tube. Place collecting basin underneath. ...

Other materials:

Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill. In order to get an accurate reading, the oil must be warm and the vehicle must be on level ground. The engine oil dipstick handle is a loop. See Engine Compartment Overview  for the location of the engine oil dipstick. 1. I ...

Intake Manifold Replacement (LUW)
Removal Procedure Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the throttle body assembly. Refer to Throttle Body Assembly Replacement. Disconnect wiring harness plug. Disconnect the pipes from ...

System maintenance
Example Basic information The two radar sensors A for the I-BSI system are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as snow, splashing water, mist or fog. The blocked condition ma ...