Chevrolet Sonic Repair Manual: Oil Pan Removal
- Remove the 16 oil pan bolts (1).
- Place a suitable prying tool to the area shown (1) and carefully pry the oil pan loose.
- Remove the oil pan (1).
Caution:
Pry the oil pan carefully in order to prevent damage to the transaxle case or the oil pan sealing surfaces.
Oil Pan Installation
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces from old sealing material, dirt, oil and grease.
Note: The seal ...
Oil Pan Replacement
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the right front wheelhouse liner extension. Refer to Front Wheel ...
Other materials:
Heated Seat Control Module Programming and Setup
The seat heating control module must be programmed with the proper calibration
software. The module stores and utilizes this information however if it is not properly
configured with the correct calibration software, the seat heating control module
will not control all of the vehicle features ...
Heater Inlet Hose Replacement (LDE, LUW)
Special Tools
BO-38185 Hose Clamp Pliers
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Drain the cooling system. Refer to Cooling System Draining and Filling.
Disengage the heater inlet hose quick connect clip (1) at the heater
...
Fluid Passages (Gen 1)
Figure 1:
Case - Control Valve Body Side (Left)
Figure 2:
Case - Pump Side (Back)
Figure 3:
Control Valve Body - Case Side (Left)
Figure 4:
Control Valve Body - Channel Plate Side (Right
- No Valves)
Figure 5:
Pump Body - Pump Cove ...
0.0075