Chevrolet Sonic Repair Manual: Oil Pressure Relief Valve Replacement
- Removal Procedure
-
- Remove the oil pan. Refer to Oil Pan Replacement.
- Remove the oil pressure relief valve closure bolt (1).
- Remove the oil pressure relief valve assembly (2).
- Separate the piston (3) and the spring (4).
- Clean the parts.
- Inspect the parts.
- Clean the thread.
Warning:
Bodily injury may occur if the cleaning solvent is inhaled or exposed to the skin.
Warning:
To avoid eye injury, use approved safety lenses, goggles, or face shield when using buffing and cleaning equipment.
- Installation Procedure
-
- Install the piston (3) and the spring (4).
- Install the oil pressure relief valve assembly (2).
- Install the oil pressure relief valve closure bolt (1) and tighten to
21 Y (16 lb ft)
.
- Install the oil pan. Refer to Oil Pan Replacement.
Caution:
Refer to Fastener Caution.
Oil Sump/Pan
...
Other materials:
Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn.
An arrow on the instrument cluster will flash in the direction of the turn or
lane change.
Raise or lower the lever until the arrow starts to flash to signal a lane change.
Hold it there until the lane change is completed. If the lever ...
GM Mobility Reimbursement Program
This program is available to qualified applicants for cost reimbursement of eligible
aftermarket adaptive equipment required for the vehicle, such as hand controls or
a wheelchair/ scooter lift for the vehicle.
For more information on the limited offer, visit www.gmmobility.com or call the
...
Special Tools
Illustration
Tool Number/Description
3-9607433
Transmission Support
DT-586
J-23129
KM-586
Universal Seal Remover
DT-3289-20
J-3289-20
Holding Fixture ...
0.0061