Chevrolet Sonic Owner's Manual: Park Brake and P (Park) Mechanism Check
Warning
When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begins to roll. Be ready to apply the regular brake at once should the vehicle begin to move.
Park on a fairly steep hill, with the vehicle facing downhill. Keeping your foot on the regular brake, set the parking brake.
- To check the parking brake's holding ability: With the engine running and the transmission in N (Neutral), slowly remove foot pressure from the regular brake pedal. Do this until the vehicle is held by the parking brake only.
- To check the P (Park) mechanism's holding ability: With the engine running, shift to P (Park). Then release the parking brake followed by the regular brake.
Contact your dealer if service is required.
Ignition Transmission Lock Check
While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF
in each shift lever position.
For automatic transmission vehicles, the ignition should turn to LOCK/OFF
only ...
Other materials:
Automatic Transmission
P (Park): This position locks the front wheels. It is the best position to use
when you start the engine because the vehicle cannot move easily.
Warning
It is dangerous to get out of the vehicle if the shift lever is not fully
in P (Park) with the parking brake firmly set. The vehicle can ro ...
Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Ensure that the steering wheel is set in a straight ahead position.
Loosen the tie rod jam nut (1).
Adjust the toe to specification by turning the inner tie rod (2). Refer
to Wheel Alignment Specifications.
Caution: Refer to Fastener Caution.
Tighten the t ...
ABS Description and Operation
This vehicle is equipped with the MGH 60 Mando electronic stability control antilock
brake system. The electronic brake control module and the brake pressure modulator
are serviced separately. The brake pressure modulator uses a four circuit configuration
to control hydraulic press ...
0.005