Brake Pedal Travel Measurement and Inspection
Park Brake Hardware InspectionPiston, Connecting Rod, and Bearing Removal
Install the crankshaft balancer bolt.
Set the pistons 1 and 4 to TDC in direction of engine rotation.
Note: Note cylinder sequence.
Mark the connecting rod with the connecting rod bearing cover (1).
Remove the 4 connecting rod bearing caps bol ...
Intake Manifold Tuning Valve Actuator Replacement
Intake Manifold Tuning Valve Actuator Replacement
Callout
Component Name
Preliminary Procedure
Properly raise and support the vehicle. Refer to Lifting and Jacking
the Vehicle.
1
Intake Manifold ...
Reverse (Gen 2)
When the gear selector lever is moved to the Reverse (R) position (from the Park
position) the normally-low 35R pressure control solenoid is commanded ON and the
following changes occur in the transmission? hydraulic and electrical systems:
3-5-Reverse Clutch Applies
Manual Valve
...