Chevrolet Sonic Repair Manual: Parking Brake Lever Replacement
- Removal Procedure
-
- Remove the front floor console. Refer to Front Floor Console Replacement.
- Ensure that the park brake lever is in the fully released position.
- Disconnect the electrical connector from the park brake warning lamp switch.
- Using ONLY HAND TOOLS, loosen the adjusting nut (1) completely to the end of the front cable threaded rod.
- Remove the park brake lever mounting nuts (1).
- While removing the front cable threaded rod from the park brake lever assembly, remove the park brake lever assembly from the vehicle.
- Installation Procedure
-
- While intstalling the front cable threaded rod to the park brake lever assembly, install the park brake lever assembly to the vehicle.
- Install the park brake lever mounting nuts (1) and tighten to 22 Y
(16 lb ft)
.
- Connect the electrical connector to the park brake warning lamp switch.
- Loosely install the adjusting nut (1) to front cable threaded rod.
- Adjust the park brake cable tension. Refer to Parking Brake Adjustment.
- Install the front floor console. Refer to Front Floor Console Replacement.
Caution:
Refer to Fastener Caution.
Parking Brake Indicator Switch Replacement
Removal Procedure
Remove the front floor console. Refer to Front Floor Console Replacement.
Ensure that the park brake lever is in the fully released position.
Disconnect th ...
Parking Brake Cable Replacement (Disc Brake)
Removal Procedure
Remove the front floor console. Refer to Front Floor Console Replacement.
Ensure that the parking brake lever is in the fully released position.
Using ...
Other materials:
Lock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1–8. The ignition cylinder
tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in
and are not self-retaining. It follows the key code with the first tumbler being
the first depth of the ...
Lift Plate and Holding Fixture Removal
Lift Plate and Holding Fixture Removal
Callout
Component Name
1
DT-46625 Transmission Holding Fixture
For equivalent regional tools, refer to Special
Tools.
Note: Raise the transmission in order to remov ...
Low and Reverse and 1-2-3-4 Clutch Housing, and 1-2-3-4 Clutch Plate Installation
(6T40/45/50)
Low and Reverse and 1-2-3-4 Clutch Housing, and 1-2-3-4 Clutch Plate
Installation
Callout
Component Name
1
Low and Reverse and 1??? Clutch Housing
Note: The longer legs face the bottom of the case and the
...
0.0048