Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Plastic Collar Quick Connect Fitting Service

Chevrolet Sonic Repair Manual / Body / General / Plastic Collar Quick Connect Fitting Service

Removal Procedure

Warning:

Refer to Gasoline/Gasoline Vapors Warning.



    Note:

    There are several types of plastic collar fuel and evaporative emission quick connect fittings used on this vehicle.

    • Bartholomew (1)
    • Q Release (2)
    • Squeeze to Release (3)
    • Sliding Retainer (4)
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief.


  2. Warning:

    Refer to Safety Glasses Warning.

  3. Using compressed air, blow any dirt out of the quick-connect fitting.

  4. This step applies to Bartholomew style connectors ONLY. Squeeze the plastic quick connect fitting release tabs.

  5. This step applies to Q Release style connectors ONLY. Release the fitting by pushing the tab toward the other side of the slot in the fitting.

  6. This step applies to Squeeze to Release style connectors ONLY. Squeeze where indicated by arrows on both sides of the plastic ring surrounding the quick connect fitting.

  7. Warning:

    Refer to Relieving Fuel Pressure Warning.

  8. This step applies to Sliding Retainer style connectors ONLY. Release the fitting by pressing on one side of the release tab causing it to push in slightly. If the tab doesn't move try pressing the tab in from the opposite side. The tab will only move in one direction.

  9. Pull the connection apart.
Installation Procedure

    Apply a few drops of clean engine oil to the male connection end.
  1. Apply a few drops of clean engine oil to the male connection end.

  2. Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.

  3. Once installed, pull on both sides of the quick-connect fitting in order to make sure the connection is secure.
How to Identify Plastic Parts
saepvcsae Plastic parts can be identified by the SAE code, which is usually found on the rear of the part, and/or by the characteristics of the plastic. Knowing the type of plastic aids in sele ...

Plastic Collar Quick Connect Fitting Service
Removal Procedure Warning: Refer to Gasoline/Gasoline Vapors Warning. Note: There are several types of Plastic Collar Fuel and Evaporative Emission Quick Co ...

Other materials:

Special Tools
Illustration Tool Number/ Description EL 35616-F J 35616 Terminal Test Kit ...

Ignition Coil Removal
Special Tools EN-6009 Remover and Installer Ignition Module For equivalent regional tools, refer to Special Tools. Remove the 2 ignition coil bolts (1). Install EN-6009 remover and installer  (2) and remove the ignition coil (1). ...

Booster seats
Precautions on booster seats WARNING Improper use of a booster seat and seat belt in the Nissan Armada significantly increases the risk of serious injury or fatal consequences for a child in the event of a sudden stop or collision. Ensure that the shoulder belt in the Nissan Armada is corr ...

В© 2014-2026 Copyright www.csmans.com
 
0.0079