Warning:
NEVER spray water on a hot heat exchanger. The resulting steam could cause personal injury.
Caution:
The heat exchanger fins are necessary for good heat transfer. Do not brush the fins. This may cause damage to the fins, reducing heat transfer.
Note:
Blow compressed air through the engine side of the radiator to remove any foreign material, such as insects, leaves, and dust.
Radiator Air Baffle Replacement (LUV, LUW)
Radiator Inlet Hose Replacement (LDE LUW)Radio Windshield Side Garnish Molding Speaker Replacement
Radio Windshield Side Garnish Molding Speaker Replacement
Callout
Component Name
Preliminary Procedure
Remove the windshield side garnish molding. Refer to Windshield Side
Garnish Molding Replacement.
1
...
Instrument Panel Center Molding Replacement (With U58)
Instrument Panel Center Molding Replacement
Callout
Component Name
1
Instrument Panel Center Molding Assembly
Procedure
Use a flat bladed plastic trim tool in the shown locations, then
rotate the trim tool 90 ...
Front Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
DT-35910 Drive Axle Boot Clamp Pliers
For equivalent regional tools, refer to Special Tools
Disassemble Procedure
Remove the wheel drive shaft from the vehicle. Refer to Front Wheel
Drive Shaft Replacement.
Install the drive axle shaft (1) i ...