Chevrolet Sonic Repair Manual: Radiator Inlet Hose Replacement (LDE LUW)
Special Tools
BO-38185 Hose Clamp Pliers
For equivalent regional tools, Refer to Special Tools.
- Removal Procedure
-
- Drain the cooling system. Refer to Cooling System Draining and Filling.
- Remove the radiator inlet hose clamp (1) at the engine using BO-38185
Hose Clamp Pliers .
- Remove the radiator inlet hose (2) from the engine.
- Remove the radiator inlet hose clamp (1) at the radiator using BO-38185
Hose Clamp Pliers .
- Remove the radiator inlet hose (2) from the radiator.
- Remove the radiator inlet hose from the vehicle.
- Installation Procedure
-
- Install the radiator inlet hose to the vehicle.
- Install the radiator inlet hose (2) to the radiator.
- Install the radiator inlet hose clamp (1) at the radiator using BO-38185
Hose Clamp Pliers .
- Install the radiator inlet hose (2) to the engine.
- Install the radiator inlet hose clamp (1) at the engine using BO-38185
Hose Clamp Pliers .
- Fill the cooling system. Refer to Cooling System Draining and Filling.
Warning: NEVER spray water on a hot heat exchanger. The resulting
steam could cause personal injury.
Caution: The heat exchanger fins are necessary for good heat transfer.
Do not brush ...
Radiator Inlet Hose Replacement
Callout
Component Name
Preliminary Procedures
Drain the engine coolant. Refer to Cooling System Dra ...
Other materials:
Starting the Engine
The vehicle has a Computer-Controlled Cranking System. It assists in starting
the engine and protects components. If the ignition key is turned to START and then
released when the engine begins cranking, the engine will continue cranking for
a few seconds or until the engine starts. If the eng ...
Programming Transmitters to the Vehicle
Only RKE transmitters programmed to this vehicle will work. If a transmitter
is lost or stolen, a replacement can be purchased and programmed through your dealer.
When the replacement transmitter is programmed to this vehicle, all remaining transmitters
must also be reprogrammed. Any lost or s ...
Air Cleaner Assembly Replacement
Air Cleaner Assembly Replacement
Callout
Component Name
1
Air Cleaner Outlet Duct Clamp.
Procedure
Loosen clamp and remove air cleaner outlet duct from air cleaner assembly.
2
Mass ...
В© 2014-2024 Copyright www.csmans.com
0.0089