|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the instrument panel center molding. Refer to Instrument Panel Center Molding Replacement. |
|
|
1 |
Radio Bolts (Qty: 4) Caution: Refer to Fastener Caution. |
|
2 |
Radio Assembly Procedure
|
Radio Rear Side Door Speaker Replacement
Radio Replacement (Without US8)Forward Collision Alert (FCA) Warning Light
These lights are on the center of the instrument panel.
The vehicle ahead light comes on when a vehicle is detected ahead and a possible
collision can occur.
The forward collision alert comes on when following a vehicle much too closely.
The light flashes when a vehicle is being rapidly ap ...
Differential Case Assemble
Special Tools
J-810721 Axle Shaft Seal Remover Support Base
R-0407011 Bearing Race Remover
R-0407012 Differential Carrier Cone Bearing Cap Driver
R-0007761 Universal Handle for Pullers and Installers
S-9407194 Speed Sensor Impeller Ring Installer
S-9407195 Pinion Gear Case Bearing I ...
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...