Chevrolet Sonic Owner's Manual: Radio Settings

Chevrolet Sonic Owner's Manual / Instruments and Controls / Vehicle Personalization / Radio Settings

Select and the following may display:

Auto Volume
Radio Favorites
Radio Tune Bar
Radio Text
XM Categories
Radio Factory Settings

Auto Volume

This feature adjusts the radio volume to compensate for road and wind noise as the vehicle speeds up or slows down, so that the volume level is consistent.

Select Off, Low, Medium, or High.

Radio Favorites

This feature sets the number of favorite pages displayed.

Press < or > to select the desired number.

Radio Tune Bar

Select to display the radio station tune bar.

Select On or Off.

Radio Text

Select to display the radio broadcast information.

Select On or Off.

XM Categories

Select to set the selection of XM categories.

Radio Factory Settings

Select to restore the radio to the factory settings.

Time & Date Settings

Select to change the settings: Set Time Format: Select 12h or 24h. Set Date Format: Press < or > to select the date display. Set Time & Date: Select, then press or to adjust th ...

Connection Settings

Select and the following may display: Bluetooth Settings Change Ringtone Ringtone Volume Bluetooth Settings Select this feature to: Connect, disconnect, or delete a device Change or ...

Other materials:

Crankshaft Front Oil Seal Installation
Special Tools EN-6351 Mounting Sleeves For equivalent regional tools, refer to Special Tools. Clean the sealing surfaces. Slide the EN-6351 sleeves (2) protective sleeve onto the crankshaft journal. Slide the crankshaft front oil seal (1) over the protective sleev ...

Power Steering Pump Belt Removal
Caution: Do not use belt dressing on the drive belt. Belt dressing causes the breakdown of the composition of the drive belt. Failure to follow this recommendation will damage the drive belt. Cut the power steering pump belt (2) with a appropriate cutting tool at ...

Drive Range, Fifth Gear Default (Gen 2)
If the transmission encounters an electrical component malfunction, the transmission will default to Fourth gear. All solenoids will default to their normal state. If the torque converter clutch is applied, it will release. The transmission will remain in Drive Range?Fourth Gear Default until ...

0.0065