Chevrolet Sonic Owner's Manual: Radio without Touchscreen
To set the time and date:
1. Press CLOCK.
2. Select Time and Date Settings.
3. Select Set Time or Set Date.
4. Turn the MENU/TUNE knob to adjust the highlighted value.
5. Press the MENU/TUNE knob to select the next value.
6. To save the time or date and return to the Time and Date Settings menu, press the / BACK button at any time or press the MENU/TUNE knob after adjusting the minutes or year.
To set the 12/24 hour format:
1. Press CLOCK.
2. Select Time and Date Settings.
3. Highlight Set Time Format.
4. Press the MENU/TUNE knob to select the 12 hour or 24 hour display format.
To set the month and day format:
1. Press CLOCK.
2. Select Time and Date Settings.
3. Highlight Set Date Format.
4. Press the MENU/TUNE knob to select MM/DD/YYYY (month/ day/year), or DD/MM/YYYY (day/month/year), or YYYY/MM/ DD (year/month/day).
Clock
The infotainment system controls are used to access the time and date settings
through the menu system. See Operation for information about how to
use the menu system. ...
Radio with Touchscreen
The infotainment system controls are used to access the time and date settings
through the menu system. See Operation for information about how to
use the menu system. ...
Other materials:
Immobilizer Light
The immobilizer light should come on briefly as the engine is started. If it
does not come on, have the vehicle serviced by your dealer. If the system is working
normally, the indicator light turns off.
If the light stays on and the engine does not start, there could be a problem
with the i ...
Instrument Panel Tie Bar Replacement
Removal Procedure
Remove the Instrument panel assembly. Refer to Instrument Panel Assembly
Replacement.
Remove the steering column and wheel from the vehicle. Refer to Steering
Column Replacement.
Remove the air inlet grill panel. Refer to Air Inlet Grille Panel Replacem ...
Inflatable Restraint Sensing and Diagnostic Module Programming and Setup
Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools.
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the ECU is not properly configured with the correct
calibration ...
0.012