Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Brake Backing Plate Replacement

Chevrolet Sonic Repair Manual / Chassis / Brakes / Drum Brakes / Rear Brake Backing Plate Replacement

Removal Procedure

Warning:

Refer to Brake Dust Warning.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  3. Remove the rear wheel speed sensor, if equipped. Refer to Rear Wheel Speed Sensor Replacement.
  4. Remove the rear brake cylinder. Refer to Rear Brake Cylinder Replacement.
  5. Remove the brake shoes. Refer to Brake Shoe Replacement.


  6. Remove the rear wheel bearing and hub assembly (1). Refer to Rear Wheel Bearing and Hub Replacement.


  7. Note:

    The park brake cable connector is part of the cable attached to the rear brake backing plate.

  8. Disconnect the front park brake cable from the park brake cable connector (1).
  9. Remove the rear brake backing plate (2).
  10. If necessary, remove the park brake cable from the rear brake backing plate by compressing the park brake cable locking tab.
Installation Procedure
  1. If removed, install the park brake cable to the rear brake backing plate.
  2. Ensure the park brake cable locking tab is fully engaged in the rear brake backing plate.

  3. Insert the front park brake cable into the park brake cable connector (1).
  4. Install the rear brake backing plate (2).

  5. Install the rear wheel bearing and hub assembly (1). Refer to Rear Wheel Bearing and Hub Replacement.
  6. Install the rear wheel speed sensor, if equipped. Refer to Rear Wheel Speed Sensor Replacement.
  7. Install the rear brake cylinder. Refer to Rear Brake Cylinder Replacement.
  8. Install the brake shoes. Refer to Brake Shoe Replacement.
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
Parking Brake Cable Replacement (Drum Brake)
Removal Procedure Remove the front floor console. Refer to Front Floor Console Replacement. Ensure that the parking brake lever is in the fully released position. Us ...

Rear Brake Cylinder Overhaul
Disassembly Procedure Warning: Refer to Brake Dust Warning. Warning: Refer to Brake Fluid Irritant Warning. Raise and support the vehicle. Refer to Lifting and J ...

Other materials:

Parking and Turn Signal Lamp Bulb Replacement
Parking and Turn Signal Lamp Bulb Replacement Callout Component Name Preliminary Procedures Open and support the hood assembly. Reposition the air cleaner inlet duct on the passenger side of the engine compartment. Re ...

Air Conditioning Compressor and Condenser Hose Replacement (LUV)
Removal Procedure Recover the refrigerant. Refer to Refrigerant Recovery and Recharging. Remove the drivetrain and front suspension frame skid plate if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement. Remove the front fascia assembly. Re ...

Engine Front Cover and Oil Pump Assemble
Oil Pump Installation Note: The oil pump slide spring and pin, as well as the slide seal and slide seal spring can be ordered as single parts. All other oil pump components can only be ordered as a replacement kit. Install the oil pump components in the fo ...

В© 2014-2024 Copyright www.csmans.com
 
0.0105