Chevrolet Sonic Repair Manual: Rear Brake Hose Replacement (Body to Axle - Drum Brake)
- Removal Procedure
-
Warning:
Refer to Brake Dust Warning.
Warning:
Refer to Brake Fluid Irritant Warning.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Disconnect the brake pipe fittings?€‰(1)?€‰from the brake hose.
- Cap the brake pipe fittings to prevent brake fluid loss and contamination.
- Remove the brake hose locking clips?€‰(1).
- Remove the brake hose.
- Installation Procedure
-
- Install the brake hose to the brackets on the rear and axle and floor panel.
- Install the brake hose locking clips?€‰(1).
- Connect the brake pipe fittings?€‰(1)?€‰to the brake hose and tighten
to?€‰ 18?€‰Y (13?€‰lb?€‰ft)
.
- Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding.
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
Caution:
Refer to Fastener Caution.
Rear Brake Hose Replacement (Body to Axle - Disc Brake)
Removal Procedure
Warning: Refer to Brake Dust Warning.
Warning: Refer to Brake Fluid Irritant Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the ...
Body Electrical
...
Other materials:
Outside Rearview Mirror Housing Cover Package Installation
Installation Instructions Part Number
95950274
Kit Contents
Tools Required
Procedure
...
Tire and Wheel Assembly Runout Measurement - On-Vehicle
Raise and support the vehicle.
Closely inspect each tire for proper and even bead seating.
If any of the tire beads were not properly or evenly seated, reseat the
tire bead, then proceed to step 4. Refer to Tire and Wheel Removal and Installation.
Wrap the circumferenc ...
Starting System Description and Operation
The starter motors are non-repairable starter motors. They have pole pieces that
are arranged around the armature. Both solenoid windings are energized. The pull-in
winding circuit is completed to the ground through the starter motor. The windings
work together magnetically to pull and hold in ...
0.0053