|
Callout |
Component Name |
|---|---|
|
Warning: Refer to Eye Protection Warning. Preliminary Procedure
Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement. |
|
|
1 |
Rear Bumper Fascia Outer Guide Rivet (Qty:?€‰5) Special Tools
BO-594-A Hand Rivet Tongs For equivalent regional tools, refer to Special Tools. |
|
2 |
Rear Bumper Fascia Outer Guide |
Rear Bumper
Rear Bumper Fascia Outer Guide Replacement (Sedan)If the Vehicle Is Stuck
Slowly and cautiously spin the wheels to free the vehicle when stuck in sand,
mud, ice, or snow.
If stuck too severely for the traction system to free the vehicle, turn the traction
system off and use the rocking method. See Traction Control/Electronic Stability
Control.
Warning
If the vehi ...
Stabilizer Shaft Replacement
Removal Procedure
Remove the intermediate steering shaft lower bolt. Refer to Intermediate
Steering Shaft Replacement.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Inst ...
Valve Lifter Installation
Special Tool
EN-845 Suction Device
For equivalent regional tools, refer to Special Tools.
Note: Observe the correct locations.
Note: Coat the sliding surfaces with NEW engine oil.
Install the 16 valve lifter (1), using the EN-845 suction device . ...