Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Compartment Lid Adjustment

Chevrolet Sonic Repair Manual / Body / Body Exterior / Panels / Rear Compartment Lid Adjustment



Rear Compartment Lid Adjustment

Callout

Component Name

1

Rear Compartment Lid

Caution:

Refer to Fastener Caution

Procedure

  1. Loosen the rear compartment lid hinge bolts (Qty:?€‰4) to adjust the rear compartment lid.
  2. Adjust the rear compartment lid in order to obtain an even gap between the rear compartment lid and the quarter outer pan the rear fog lamp and the rear bumper fascia and so that the rear compartment lid is flush with the quarter outer panel, the rear fog lamp and the rear bumper fascia.
  • Rear compartment lid to quarter outer panel

    (a) 3.0?€‰mm ?± 0.75?€‰mm (0.12?€‰in ?± 0.03?€‰in)

  • Tail lamp to rear compartment lid

    (b) 3.0?€‰mm ?± 1.0?€‰mm (0.12?€‰in ?± 0.04?€‰in)

  • Rear compartment lid to rear bumper fascia

    (c) 5.5?€‰mm ?± 1.5?€‰mm (0.22?€‰in ?± 0.06?€‰in)

Tighten


22?€‰Y (16?€‰lb?€‰ft)

Radiator Grille Bumper Replacement
Radiator Grille Bumper Replacement Callout Component Name Preliminary Procedure Remove the front bumper fascia. Refer to Front ...

Rear Compartment Lid Hinge Torque Rod Replacement
Rear Compartment Lid Hinge Torque Rod Replacement Callout Component Name Warning: Refer to Hood Hold-Open Device Warning. ...

Other materials:

Brake System Warning Light
The vehicle brake system consists of two hydraulic circuits. If one circuit is not working, the remaining circuit can still work to stop the vehicle. For normal braking performance, both circuits need to be working If the warning light comes on, there is a brake problem. Have the brake system ...

Vehicle Yaw Sensor Replacement
Vehicle Yaw Sensor Replacement Callout Component Name Preliminary Procedures Turn the ignition OFF. Remove the front floor console. Refer to Front Floor Console Replacement. 1 Yaw Sensor Nut ...

Camshaft Installation
Special Tools EN-422 Installer For equivalent regional tools, refer to Special Tools. Note: Coat with MoS 2 lubricating paste. Refer to Adhesives, Fluids, Lubricants, and Sealers. Install the intake camshaft (1). Note: Note the identification mark ...

© 2014-2025 Copyright www.csmans.com
 
0.0061