Chevrolet Sonic Repair Manual: Rear Compartment Lid Nameplate Replacement (Sedan)

Chevrolet Sonic Repair Manual / Body / Body Exterior / Identification Plates / Rear Compartment Lid Nameplate Replacement (Sedan)

Rear Compartment Lid Nameplate Replacement
Callout	Component Name
1	Rear Compartment Lid Nameplate Caution: Refer to Exterior Trim Emblem Removal Caution. Procedure The part and surface should be 21?°C (70?°F) prior to installation. The vehicle should remain 21?°C (70?°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Use a Heat Gun or equivalent to remove the old nameplate. Clean all adhesive from the rear compartment panel and wipe the surface dry with a clean lint-free towel prior to installing the new nameplate. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion. Close the rear compartment lid prior to adhesion. Using the palm of the hand, wet out the emblem to the rear compartment lid to ensure full adhesion of the emblem is made.

Radiator Grille Emblem/Nameplate Replacement

Radiator Grille Emblem/Nameplate Replacement Callout Component Name Preliminary Procedure Remove the front bumper fascia. Refer to ...

Moldings

...

Other materials:

Rear Window Reveal Molding Replacement
Rear Window Reveal Molding Replacement Callout Component Name Preliminary Procedures Remove the rear window to replace the reveal molding. Refer to Rear Window Replacement. 1 Rear Window Reveal ...

Automatic Transmission Flex Plate Removal
Special Tools EN-652 Automatic Transmission Flex Plate Holder For equivalent regional tools, refer to Special Tools. Install the EN-652 holder (1) to hold the automatic transmission flex plate (2). Loosen the 6 automatic transmission flex plate bolts. Remov ...

Drive Range, First Gear Engine Braking (Gen 1)
When the gear selector lever is moved to the Drive (D) range from the Neutral (N) position, the transmission will provide engine braking. In this operating range, the normally-low 1234 pressure control solenoid 5 is commanded ON and, in the engine braking mode, the following changes occur with ...

0.0079