Callout |
Component Name |
---|---|
Preliminary Procedure
Remove the rear compartment lid inner panel trim. Refer to Rear Compartment Lid Inner Panel Trim Replacement. |
|
1 |
Rear Compartment Lid Bolt (Qty:?€‰4) Caution: Refer to Fastener Caution.
9?€‰Y (80?€‰lb?€‰ft) |
2 |
Rear Compartment Lid Procedure
|
Disarming the System
To disarm the system, either unlock the doors using the RKE transmitter, or start
the vehicle with a recognized transmitter in the vehicle.
To avoid setting off the alarm by accident:
Press on the RKE transmitter.
Start the vehicle.
To avoid setting off the alarm by accident:
Lock t ...
Removing the Flat Tire and Installing the Spare Tire
1. Do a safety check before proceeding. See If a Tire Goes Flat.
2. Remove the wheel cover, if the vehicle has one, to reach the wheel bolts.
3. Turn the wheel nuts counterclockwise to loosen them. Do not remove them yet.
4. Place the jack at the position marked with a half circle.
5. In ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...