Chevrolet Sonic Repair Manual: Rear Disc Brake Mounting and Hardware Inspection

Chevrolet Sonic Repair Manual / Chassis / Brakes / Disc Brakes / Rear Disc Brake Mounting and Hardware Inspection

Warning:

Refer to Brake Dust Warning.

Caution:

Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

Without disconnecting the hydraulic brake hose fitting, remove rear brake caliper and support with heavy mechanics wire. Refer to Rear Disc Brake Pads Replacement.

Remove the disc brake pads (1) from the brake caliper mounting bracket (2).
Inspect the disc brake pad mounting hardware (3) for the following:

Missing mounting hardware.
Excessive corrosion.
Bent pad retainer spring.
Looseness at the brake caliper bracket.
Looseness at the disc brake pads.
Excessive contaminants in the brake caliper bracket surface and caliper bracket bolt threaded holes.

If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.

Ensure the disc brake pads are held firmly in place on the caliper bracket, yet slide easily on the mounting hardware without binding.

Install the disc brake pads to the caliper bracket.

Install the rear brake caliper to the bracket. Refer to Rear Disc Brake Pads Replacement

Rear Brake Shield Replacement

Removal Procedure Warning: Refer to Brake Dust Warning. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the rear tire and wheel assembl ...

Rear Wheel Bearing and Hub Replacement (Disc Brake)

Special Tools EN–45059 Angle Meter For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suitably support the vehicle. Refer to Lifting and Jacking ...

Other materials:

OnStar Description and Operation
This OnStar® system consists of the following components: Telematics communication interface control module OnStar® three button assembly Microphone Cellular antenna Navigation antenna Bluetooth® antenna (If equipped) Back up battery (If equipped) This system also interfaces wi ...

Battery Disconnect Warning
Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in c ...

Transmission System Description and Operation
The F17 is a 5 speed manual transmission assembly. Note: Use only transmission fluid listed within the Adhesives, Fluids, Lubricants, and Sealers for this manual transmission assembly. Other lubricants or additives may affect the shift performance. The F17 (Gen 1) 5 Speed m ...

0.0075