Chevrolet Sonic manuals
 

Chevrolet Sonic Repair Manual: Rear End Panel Replacement

Chevrolet Sonic Repair Manual / Body / Body Exterior / Panels / Rear End Panel Replacement

Removal Procedure

    Warning:

    Refer to Approved Equipment for Collision Repair Warning.

    Warning:

    Refer to Glass and Sheet Metal Handling Warning.

    Note:

    The rear end lower panel reinforcement extension is made of Ultra High Strength Dual Phase Steel and should be replaced only at factory joints. Repairing or sectioning of this part is not recommended. Refer to Ultra High Strength Dual Phase Steel.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

    6. Note:

    Note the number and location of welds for installation of the service assembly.

  6. Locate and mark all the necessary factory welds of the body rear end panel.

  7. Drill all factory welds (1).

  8. Remove the body rear end panel (1).
Installation Procedure


    Note:

    If the location of the original plug weld holes can not be determined, space the plug weld holes every 40?€‰mm (1 1/2?€‰in)

    .

  1. Drill 8?€‰mm (5/16?€‰in)

    holes for plug welding along the edges of the body rear end panel (1) as noted from the original panel.

  2. Clean and prepare the attaching surfaces for welding.

  3. Position the body rear end panel on the vehicle (1).
  4. Verify the fit of the body rear end panel.
  5. Clamp the body rear end panel into position.

  6. Plug weld accordingly.
  7. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.
  8. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.
  9. Install all related panels and components.
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  11. Enable the SIR system. Refer to SIR Disabling and Enabling.
Front Fender Replacement
Front Fender Replacement Callout Component Name Preliminary Procedures Remove the front bumper fascia. Refer to Front Bumper Fascia ...

Roof Panel Joint Finish Molding Replacement
Roof Panel Joint Finish Molding Replacement Callout Component Name Caution: Refer to Exterior Trim Emblem Removal Caution. ...

Other materials:

Driving on Snow or Ice
Drive carefully when there is snow or ice between the tires and the road, creating less traction or grip. Wet ice can occur at about 0°C (32°F) when freezing rain begins to fall, resulting in even less traction. Avoid driving on wet ice or in freezing rain until roads can be treated with sa ...

Steering Wheel Replacement
Steering Wheel Replacement Callout Component Name Preliminary Procedure Remove the inflatable restraint steering wheel module. Refer to Airbag Steering Wheel Module Replacement. Use paint in order to place match marks on ...

Instrument Panel Outer Air Outlet Replacement - Right Side
Instrument Panel Outer Air Outlet Replacement - Right Side Callout Component Name Preliminary Procedure Remove the right instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Panel Replacement - Right Side ...

© 2014-2024 Copyright www.csmans.com
 
0.0057